Cyberpower-systems PR1500 Manual de usuario descargar pdf (Pagina 10)

1

DEFINITIONS FOR LED INDICATORS

Power

On

Wiring

Fault

AVR

Using

Battery

Circuit

Breaker

Alarm

Condition

On Off Off Off Set Off

Normal

On Off Flash Off Set Off

AVR- Max. boost 15% of input

voltage for output regulation

while input voltage is from 8% to

30% under nominal.

ON Off On Off Set Off

AVR- Max. buck 15% of input

voltage for output regulation

while input voltage is from 8% to

26% over nominal.

Off On/Off Off On Set

Two

Beeps

Utility Failure- The UPS is

providing battery power to the

Battery-Power Supplied outlets.

Off On/Off Off On Set

Rapid

Beeps

Utility Failure- The UPS is

providing battery power.

Rapid beeps indicate the

battery will run out of charge

within a few minutes.

On/Off On/Off

On/ Off

/Flash

On/Off Set

Long

Beep

Overload- Turn the UPS off

and unplug at least one piece of

equipment from the UPS. Wait

5 seconds, reset the circuit

breaker and restart the UPS.

Off Off Off On Up

Long

Beep

Overload- Turn the UPS off

and unplug at least one piece of

equipment from the UPS. Wait

5 seconds, reset the circuit

breaker and restart the UPS.

On On/Off

On/ Off

/Flash

Off Set None

Weak Battery- Recharge the

battery for at least 8 hours. If

Check Battery is illuminated,

contact CyberPower Systems

for battery replacement

information.

Off Off Off Off Set Off

Surge Protection

Malfunction- Power surge has

damaged the unit. Please

contact CyberPower Systems

On/Off On

On/ Off

/Flash

On/Off Set/Up None

Electrical Wiring Fault-

Indicates wiring problems such

as a bad ground, missed

ground or reversed wiring

within the AC outlet. User is

advised to disconnect all

electrical equipment from the

outlet and have the outlet

checked by an electrician.

8

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17 18

Comentarios a estos manuales

Sin comentarios